鋼制拖鏈

使用微信掃描二維碼分享朋友圈，成交更快更簡單！

1、鋼鋁拖鏈http://www.hengtonght.com產品產地：德州恒通     
2、產品特性：TLG型鋼制拖鏈可承載數量多，重量大的電纜及油管，自由懸置（允許不用支撐輪）長度大，支持板可依客戶需要制作，適用于工作母機，移動機器等。TLG型鋼制拖鏈可帶塑料隔條，可隨意移動調節位置，進行多種分割。支撐板寬度在高達1200mm時，仍可在確保內置電纜處于最佳保護狀態的條件使之做最高速度的移動。http://www.ht218.comTLG 型鋼制拖鏈可根據客戶的需隨時加裝銀色護板，實踐證明此裝置在非人為故意破壞前提下至少可經受15年以上的考驗。產品外部和內部均可安裝彈性鋼帶，以保護內置電纜和保持內部的清潔，安全可靠。
3、產品型號：齊全，可根據客戶要求定做。http://www.ht612.com

TLG drag chain    Character:
  The TLG drag chains are suitable for installing a large quantity and heavy duty of cables and oil pipes which allow suspending installation (supporting is not allowed)and is lengthy.The supporting plate can be made according to the users requirements.It is suitable for machine tools and moving machines.Their bebt radius ranges from 50-600mm and the chains height is from 35 to 150mm.users can
make a free selection of them.
  The TLG type drag chains have a max travel range of 32 meters and suitable for all kind of transmissions.It can freely be made longer or shaort.In addition,the bend radius can be changed by changing the pin shaft.
  The TLG width of the supporting board is from 150mm to 600mm.the distance between the holes is 5mm.
  The height of the supporting board depends on the max.outside diameter of the cable.When the machine tool is working in the highest speed and if the max the width of the drag chain is longer than 4m,onesize larger than normal should be selected just out of considerationof safety.
  The bend radius should be selected according to the max.diameter of a cable and should be 10 times of the cable used.The bend radius can be selected as 50-600mm according to the given table.Small radius should be selected for those ones with small travel range.
  Drag chain length=1/2travel range+4 bend radius,this is only used for the fixed connection which is located at the middle point of the travel range.
  The fexation of the drag chains can be done according to the machine tools.The angle steel can be put in the outer or the inner,in other words,in the inner side of the chains of in the oute side.In common cases,it is in the inner side of the chains and face towards outside.