NR型數字深水溫度計
此數字深水溫度計主要用于測量深水溫度,也可以用來測量任何無腐蝕性介質的溫度。測量范圍可達-45℃~125℃。此溫度計在0℃~40℃范圍內標定。
技術指標:
測量范圍:-45℃~125℃
適用水深:40m(電纜長度依用戶需要配備)
電 源:支流4.5v,3節5號電池
功 耗:最大電流80mA
誤 差:0℃~40℃:最大誤差0.5℃
-45℃~125℃: 最大誤差2℃
分 辨 力:0.1℃
響應時間:自然水溫下不大于6秒。
顯示:3位半LED顯示,小數點后1位。
使用方法:
將傳感器放入水中欲測溫度位置,按下表殼上的按扭,數秒鐘后即可顯示所測溫度值。
更換電池:
擰開后蓋上的螺釘,取下后蓋,即可按電池盒上的正負極安裝電池。
注意:
電路板上的兩個電位器已標定好溫度計的精度,請不要?jiǎng)印?/div>
This figure sham thermometer mainly used to measure temperature, can also be used to measure any non-corrosive medium temperature.
Measuring range can up to -45 ℃ ~ 125 ℃. The thermometer calibrate within 0 ℃ ~ 40 ℃.
Specifications:
1. Measuring range: -45 ℃ ~ 125 ℃
2. Apply depth: 40 m (according to user needs with cable length )
3. Power: tributary of 4.5 v, 3節on the 5th Battery
4. Power consumption: 80 mA maximum current
5. Error: 0 ℃ ~ 40 ℃: the greatest error of 0.5 ℃
-45 ℃ ~ 125 ℃: the greatest error of 2 ℃
6. Resolution: 0.1 ℃
7. Response time: natural water temperature of not more than six seconds.
8. Display: 3-LED display, one after the decimal point.
How to use:
Add to sensors will measure water temperature position, press the button on the case, after a few seconds to display the measured temperature.
The replacement of batteries:
After opening with a twist of the screws, remove the rear cover, according to the battery box is on the negative battery installed.
Note:
The two boards have potential for good thermometer calibration of precision, please do not move.